6.Have an assistant hold the dies as you remove the flat head cap screws, then remove both dies from the machine.
Note: To aid in
7.Thoroughly clean the dies and mounting area with a solvent or mineral spirits to remove debris, mill flash, and
Note: If you will be storing the dies, protect them with a light coat of an
8.Make sure the beam is in proper alignment with the panels (Page 42).
9.Back the bottom die adjustment screws (see Figure 59) out until they no longer protrude from the inside face of the front panel.
10.Wipe a light coat of lubricant on all surfaces of the dies (refer to Figure 18 on Page 22).
11.Install the bottom die and fully tighten the flat head cap screws to secure the die tight to the front panel.
12.Install the top die and fully tighten the cap screws to secure it in place.
13.Reconnect the machine to power, and turn it ON.
14.Set the controls to Notch and Inch, bring the top die down and behind the bottom die.
15.Turn the motor OFF, and press the emer- gency stop button to avoid unexpected move- ment of the tooling.
16.Loosen the bottom die cap screws
17.Use the feeler gauge and adjust the bottom die set screws until the clearance between the top and bottom dies is 0.004" (0.1mm) along their full length.
18.When you are satisfied with the clearance adjustment, fully tighten the bottom die cap screws, and
19.
20.
Angle Iron Shearing
Dies
Each of the dies at the angle iron shearing station have four different mounting positions to use a different set of cutting edges.
Because of the critical positioning in relation to each other, these dies cannot be sharpened. When they become damaged or dull, call Grizzly Tech Support at (570)
To
Tools Needed | Qty |
Hex Wrench 8mm | 1 |
Hex Wrench 10mm | 1 |
To remove the angle iron shearing dies: |
|
1.Turn the motor OFF, and press the emergen- cy stop button to avoid unexpected tooling movement.
2.Remove the shearing
3.Set the controls to Notch and Inch, reset the emergency stop button, then turn the machine ON.
