Windows NT | Harmony House 802.11a specs

Installation

18

Windows NT

Follow these steps to install a Harmony 802.11a network adapter in a computer running Windows NT 4.0 (Service Pack 6 or later).

1.Turn on the computer and logon to Windows, if applicable.

2.Insert the Harmony Installation CD into the computer’s CD-ROM drive.

3.If the Harmony Installation program does not launch automatically, run SETUP.EXE from the Harmony Installation CD to launch the program, shown in the following example.

4.Click Next to continue.

5.Select a destination folder for the Harmony Utility files and click Next to continue.

6.Enter a name for the utility’s Program Manager group and click Next.

7.Click Next to install the utility.

8.Click Finish to view additional information about the utility.

Note: To avoid viewing the additional information, uncheck the Read Harmony configuration instructions box before clicking Finish.

9.Click Finish to complete the Harmony Utility installation and to continue the installation of a Harmony 802.11a network adapter.

Image 18

Harmony House 802.11a manual Windows NT

Contents

Harmony 802.11a Network Adapter Users Guide FCC Warning Declaration of Conformity That the following harmonized standards have been applied For Indoor Use Only Table of Contents Index Chapter Introduction Harmony Family Product Package Harmony 8450 802.11a CardBus CardHarmony 8150 802.11a PCI Card System Requirements Overview of Country-Specific Features Regulatory Warnings InstallationPre-installation Considerations FCC Guidelines Windows ME and Windows 98 SE Installation CD Requirement Industry Canada Guidelines Windows NT Laptops Require a Plug-and-Play Utility 802.11a CardBus Card Installation Instructions Windows 98SE/ME/2000/XPPage Page Windows NT Page Harmony 802.11a PCI Card users Follow these steps Related Topics Upgrading to Version Wireless Topologies Ad Hoc Connecting to a Single AP Infrastructure Roaming Between Multiple APs Roaming Guidelines for Roaming Configuration Parameters Ieee 802.11a Specification Network Mode 802.11a Software Parameters Power Saving Mode 2X ModeRoaming For Europe ChannelFor United States and Canada For Japan Send Rate FragmentationFor Singapore WEP Encryption and Authentication Security Options Harmony Security Protocol WEP Keys 802.1x Harmony Security Protocol Guidelines Configuration Parameters Harmony Utility Status Monitor Icon Configuration Utility Association Information Harmony Utility Station Configuration Harmony Utility Harmony Utility WEP for Authentication and Encryption SecurityPage Read Key File Format Harmony Security Protocol Page Page Page 802.1x Click the Authentication tab Click the Wireless Networks tab Network Traffic Statistics Send Receive 802.11a Networks Snoop Tool Packet Transmission Success Rate Version Information Troubleshooting How to Obtain Help with Your LAN InstallationCommon Installation Problems Windows 98/ME/2000/XP Troubleshooting Adapter Inserted Before Running the Installation Program 802.11a Network Adapter Not Installed Properly Adapter Not Listed in Device Manager Configuring Networking Clients and Protocols Windows XP/2000Windows ME/98 SE Uninstalling a Harmony 802.11a Network Adapter Windows NT Windows NT computers RangeWindows 98/ME computers Windows 2000 computers CardBus Card LED Indicators Common Technical Support Questions Access Point is out of range box and click Logon Password so the Harmony logon General Technical SpecificationsTechnical Specifications Network Information Radio EnvironmentalPhysical Parameters Ssid Appendix B Technical Support and Training Index Infrastructure Network Mode Ssid Throughput Topologies