Hearth and Home Technologies CERONA-42 owner manual Getting Started, Tools and Supplies Needed

2 Getting Started

A. Design and Installation Considerations		C. Inspect Appliance and Components
Heat & Glo direct vent gas appliances are designed to			WARNING
operate with all combustion air siphoned from outside of
the building and all exhaust gases expelled to the out-			Inspect appliance and components for damage.
side. No additional outside air source is required.
			Damaged parts may impair safe operation.
	CAUTION		• Do NOT install damaged components.
			• Do NOT install incomplete components.
	Check building codes prior to installation.		• Do NOT install substitute components.
			Report damaged parts to dealer.
	• Installation MUST comply with local, regional, state and
	national codes and regulations.
	• Consult local building, fire officials or authorities having jurisdic-	•	Carefully remove the appliance and components from
	tion about restrictions, installation inspection, and permits.		the packaging.
When planning an appliance installation, it’s necessary to		• The vent system components and trim doors are shipped
			in separate packages.
determine the following information before installing:		• The gas logs may be packaged separately and must be
•	Where the appliance is to be installed.
			field installed.
•	The vent system configuration to be used.	•	Report to your dealer any parts damaged in shipment,
•	Gas supply piping.		particularly the condition of the glass.
•	Electrical wiring.	• Read all of the instructions before starting the insta-
•	Framing and finishing details.		llation. Follow these instructions carefully during the
			installation to ensure maximum safety and benefit.

•Whether optional accessories—devices such as a fan, wall switch, or remote control—are desired.

		WARNING		WARNING
				Hearth & Home Technologies disclaims any
				responsibility for, and the warranty will be voided
Keep appliance dry.				by, the following actions:
•	Mold or rust may cause odors.		•	Installation and use of any damaged appliance or vent
•	Water may damage controls.			system component.
			•	Modification of the appliance or vent system.
B. Tools and Supplies Needed			•	Installation other than as instructed by Hearth & Home
				Technologies.
Before beginning the installation be sure that the following			•	Improper positioning of the gas logs or the glass door.
tools and building supplies are available.			•	Installation and/or use of any component part not approved
				by Hearth & Home Technologies.
Reciprocating saw		Framing material	Any such action may cause a fire hazard.
Pliers		Hi temp caulking material
Hammer		Gloves
Phillips screwdriver		Framing square
Flat blade screwdriver		Electric drill and bits (1/4 in.)
Plumb line		Safety glasses
Level		1/2 - 3/4 inch length, #6 or #8 Self-drilling screws
Manometer		Voltmeter
Tape measure		Noncorrosive leak check solution

One 1/4 inch female connection (for optional fan).

6 Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. H • 11/08