Honeywell Vista-50P/Vista-50PUL manual Table of Contents

Table of Contents

Recommended Programming Procedure	3	Relay Programming	25
Program Field Index	4	Relay Voice Descriptors	28
VISTA-50P/VISTA-50PUL Programming Form	5	Relay Voice Descriptors and Custom Word
Partition-Specific Fields	10	Substitutes Vocabulary	29
		Custom Word Substitutes for VIP Module
Programming With #93 Menu Mode	12
		Annunciation	30
Zone Programming	13
		System Layout Worksheets	31
5800 Series Transmitters Loop Designations	15
		Relay Devices Worksheets	39
Expert Mode Zone Programming	16
		Scheduling Menu Prompts	41
Alpha Descriptors Programming	20
		Scheduling Worksheets	42
Alpha Descriptor Vocabulary	23
		VISTA-50P/VISTA-50PUL Summary of
Device Programming	24
		Connections Diagram	47

The purpose of this document is to provide a quick and easy way to program your entire system. A recommended programming procedure is included, followed by a list of program fields with the corresponding program group they belong to (system-wide, partition-specific, scheduling, etc.). Two program forms are included. One contains all the programming fields, and the other contains the partition-specific fields. If you are setting up a single-partition system, the partition-specific fields become system-wide fields.

Following the program forms are system layout worksheets. We recommend that you use these sheets to plan your system before programming is performed. If you need further information about specific programming options, see the ADEMCO VISTA-50P/VISTA-50PUL Installation and Setup Guide.

Make sure that one two-line alpha keypad is connected to the control and is set to device address "00."

Single-Partition System

The system default is for a single-partition system. Use the VISTA-50P/VISTA-50PUL SINGLE PARTITION PROGRAMMING FORM when programming for single-partition usage. Follow the steps outlined in RECOMMENDED PROGRAMMING PROCEDURE of this document for proper programming procedure.

Multiple-Partition System

You must enter the number of partitions you are using in data field 2*00 to set the system for multiple partitions. Use the VISTA-50P/VISTA-50PUL SINGLE PARTITION and the PARTITION-SPECIFIC PROGRAM FORMS when programming the system for multiple partitions. Follow the steps outlined in RECOMMENDED PROGRAMMING PROCEDURE of this document for proper programming procedure.

SUMMARY OF PROGRAMMING COMMANDS

•To enter program mode, enter installer code + [8] + [0] + [0]

•To set standard defaults, press ✱97

•To change to next page of program fields, press ✱94

•To return to previous set of fields, press ✱99

•To erase account and phone number field entries, press [✱] + field number + [✱]

•To assign zone descriptors, press #93 + follow menu prompts

•To add custom words, press #93 + follow menu prompts

•To enter Installer's Message, press #93 + follow menu prompts

•To exit program mode, enter ✱99 OR ✱98: ✱99 allows re-access to programming mode by installer code. ✱98 prevents re-access to programming mode by installer code.

Standard default (✱97) values are shown in brackets [ ], otherwise default = 0.

– 2 –