Honeywell Ademco Vista Series Commercial Burglary Partitioned Security System With Scheduling

Relay Devices Worksheets

Applicable only if relays (4204), or X-10 devices are used.

￿Relays are programmed in the #93 Menu Mode in the Relay Programming Section. Fill in the required data on the worksheet below and follow the procedure in the Installation and Setup Guide as you enter the data during the displays and prompts that appear in sequence.

Notes: 1. For 4204 the Device Programming section must be programmed for the device address. Set the DIP switches on the device for that address.

OUTPUT DEV #

2.For X-10 devices, use the 1361X10 transformer in place of the transformer that comes in the box with the control panel.

		S T	A R T	S T	O P	Relay		1=4204	Dev Add 4204	Relay # for
										4204 or
A							Restrict		or House Code
	EV/ZL		ZT / P	ZL	ZT / P	Group		2=X-10		Unit Code for
									for X-10
										X-10

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
A =	DEVICE ACTION	0 = No Response; 1 = Close for 2 sec; 2 = Close and stay closed; 3 = Pulse on and off
EV =	EVENT	0 = Not used; 1 = Alarm; 2 = Fault; 3 = Trouble; 4 = Restore
ZL =	ZONE LIST	1-8, 0 = Not Used
		"START" ZONE LIST:	Upon alarm, fault, trouble or restore of ANY zone in this list, device
			action will START.
		"STOP" ZONE LIST:	Upon restore of ALL zones on this list, device action will STOP. It
			need not be same list as used for START.

— 39 —