rolls? media dual use I do How
7.Use the front panel feed menu to feed enough additional media through the media feederto provide two full turns on the
8.At the rear of the printers, set the white media winding direction switch (1) to the OFF position.
9.Turn the
10.Feed enough additional media through the media feeder to create a slack area (approximately 30 cm) in the media sufficient to install the tension bar.
11.Mount the flanges on the tension bar, refer to Tension bars.
12.Adjust the positions of the flanges (1) on the tension bar, on the
118 | Chapter 3 How do I use dual media rolls? | ENWW |