23.Close the rear cover.
To complete the procedure, follow the front panel instructions.
24.Confirm the position of the media edge guards and press the OK key.
25.Select the media feed position.
a.Select BACKm using the 
or 
keys.
b.Press the OK key to confirm the selection.
26.Select a media type.
a.Select the media type using the 
or 
keys.
b.Press the OK key to confirm the selection.
If the mesh tarpaulin media has not yet been registered, enter it.
NOTE If the mesh tarpaulin media is narrower than the liner, set “DETECT WIDTH” to “NONE” in the MEDIA REG menu. Selecting “AUTO” lets the printer detect the liner width as the mesh tarpaulin width and to print at the right edge of the liner.
The contents to set with the MEDIA REG menu are the following (Refer to Media width detection (WIDTH DETECTION)):
●DETECT WIDTH — NONE
●MEDIA WIDTH — Enter the mesh tarpaulin media width
●LINER WIDTH — Enter the liner width.
NOTE To change the operational mode from “AUTO” to “RIGHT ONLY” OR “NONE” after media has been detected in “AUTO” mode, raise and lower the media load lever to reset the media. This will change the operational mode.
27.Select whether or not a liner is used.
How do I print with a liner
ENWW | Print on mesh tarpaulin (without dedicated liner) | 177 |