media basic perform I do How perations?o
●If the tension bar is going to be installed in the slack area of the media, use one or more tension bars
(3) to create a total length that is equivalent to half the width of the media and do not install the flanges (1), ESD flange (4) and the
●If the tension bar is going to be installed in the tension bar guides, use the required tension bars to create a total length that is equivalent to the width of the printer, at the left hand end install one standard flange (1) and one ESD flange (4) , slide the
CAUTION You must always clean the fixing ring and tension bar using alcohol to remove any dirt because this could cause the fixing ring to become displaced during
●Install the flanges at each end of the tension bar. When you insert the tension bar into the flange, align the cutouts in the flange with the screw heads in the tension bar.
NOTE For vinyl chloride (PVC) media assemble the tension bar in the same way as for the feed side (no flanges,
Use media tube flanges
You use the media tube flanges to
The following flanges are supplied:
●3 x rubber spacer A (1)
●3 x rubber spacer B (2)
●1 x rubber spacer C (3)
60 | Chapter 2 How do I perform basic media operations? | ENWW |