24.At the front of the printer, use the black media advance switch to feed the media (1) on the main scroller enough so that you can install the tension bar in the slack area.

NOTE If there is an obvious difference in the amount of media feed between the main scroller and sub-scroller, you should try to adjust the sub-scroller back tension to improve the difference in feed, refer to Adjust the back tension of the sub-scroller

25.Install the tension bar (2) in the supports (1).

CAUTION Make sure you install the tension bar with the ESD contact ring at the right hand end of the tension bar (viewed from the front of the printer).

NOTE The tension bar is not used for the media on the sub-scroller.

How do I use dual media rolls?

ENWW

Install dual media rolls on separate scrollers

107