Status: | Status of maintaining each heater temperature at the preset temperature on the heater front | |
| panel. | |
|
|
|
Conditions: | 1. | If the heater ON/OFF setting on the heater front panel is set to ON and a print command is |
|
| received. |
| 2. | Under condition (1) above, and the time specified by the delay time after the print end |
|
| command was received. |
|
|
|
Maintaining the standby temperature
Function: | To shorten the time needed to reach the preset temperature to start printing. |
|
|
Status: | Status of maintaining the heater temperature at the specified standby temperature (35 °C) for all |
| heaters. |
| When the preset temperature is lower than the specified standby temperature (35 °C), the printer |
| maintains the preset temperature. |
|
|
Conditions: | If the standby time has been set, after reaching the preset temperature. |
|
|
Turning off the heaters
Function: | To prevent excessive current consumption, to protect the media from damage by the heat from |
| the heaters, and to protect the user from getting burned from touching the heaters when printing |
| is not performed. |
|
|
Status: | Status of reaching the environmental temperature slowly. |
|
|
Conditions: | In all cases except when maintaining the preset temperature or the standby temperature. |
|
|
|
|
Start of heating: | The print start command is received and heating starts. Printing does not start until the heaters |
| have reached the preset temperature. |
|
|
Start of print: | The heaters reach the preset temperature and printing starts. |
|
|
End of print: | The print end command is received and printing finishes. |
|
|
The heater front panel
Display in normal mode
Tell me about the heaters
ENWW | Heater temperature settings | 305 |