Dual media rolls
This procedure describes how to
1.Install two suitable empty media tubes on the main scroller, as described in Dual media rolls
2.Install rubber spacers (1) on the flange spacers as necessary (Refer to Use media tube flanges).
3.Temporarily install the four media tube flanges (1) on the rubber spacers at the both ends of each media tube. You will adjust the position of these later according to the actual media width.
4.To complete the operation follow the instructions from step 3 of the Dual media rolls
Adjust the back tension of the
If there is an obvious difference in the amount of media feed between the main scroller and
How do I use dual media rolls?
ENWW | Adjust the back tension of the | 125 |