Introduction
The printer's heaters
This section describes how to control the printer's heaters used for drying the printed media.
The heater's front panel
The heater's front panel is located on the front of the printer, on the
1.The display screen, at the top of the panel, shows the target temperature and the current temperature of each heater.
2.The three On/Off switches turn the three heaters on or off. The three pairs of 
or 
keys can be used to raise or lower the target temperatures of the respective heaters.
Defining heater parameters
1.On the heater front panel press the On/Off key, and the 
and 
keys at the same time to enter the parameter setup mode.
2.Select a setup parameter using the 
and 
keys on the heater front panel and press the On/Off key on the heater front panel to modify the setup item displayed.
3.Use the 
and 
keys to select the value and press the On/Off key to confirm.
NOTE If you have selected an incorrect setup value, you can press the On/Off key again to cancel the setting and repeat from step 2.
12 | Chapter 1 Introduction | ENWW |