19.At the wiper end of the tension bar (1), adjust the take-up bar flange (3) position for the width of the media, leaving a 2 mm gap, and lock it in position with the two O-rings (2).

media basic perform I do How perations?o

20.At the capping end, adjust the take-up flange (1) on the tension bar (2) so it is positioned against the edge of the media (without the fixing O-rings).

21.At the rear of the printer, set the white media winding direction switch (1) to the correct position for the direction the media is to be taken-up, inner take-up (A) or outer take-up (B).

56

Chapter 2 How do I perform basic media operations?

ENWW