a.Select the media type using the 
or 
keys.
b.Press the OK key to confirm the selection.
19.Select whether or not a liner is used.
a.Select liner use requirement using the 
or 
keys. If a liner is used.
b.Press the OK key to confirm the selection.
20.At the front of the printer, use the black media advance switch to loosen the media enough to be able to install a tension bar (2) of approximately half the media width in the slack area of the media (1).
The media setting operation starts automatically.
Verify the front panel shows this message and press the OK key.
NOTE The next operation will not start if the media is too tight.
136 | Chapter 4 How do I perform | ENWW |