HP BL e-Class Replacing an Existing Interconnect Tray

Setting up and Installing the Interconnect Switch

Replacing an Existing Interconnect Tray

To replace an existing interconnect tray:

1.Upload the current switch configuration to a TFTP server. Refer to the “Saving Settings to a TFTP Server” section in the management interface reference guides.

IMPORTANT: HP recommends saving the switch module configuration to a TFTP server once the switch module configuration is complete or has changed.

Figure 2-5: Removing a hot-plug power supply

2. Press the port-colored latch to release one hot-plug power supply (1).

IMPORTANT: Port-color indicates hot-plug components.

3.Pull the handle to its open position (2).

4.Slide the hot-plug power supply out of the server blade enclosure (3).

5.Repeat steps 2 through 4 to remove the other hot-plug power supply.

Figure 2-6: Removing the old interconnect tray

6. Press both interconnect tray release buttons (1).

2-4 HP ProLiant BL e-Class C-GbE Interconnect Switch User Guide