HP BL P-CLASS GBE2 331404-008 802.1x Port configuration, off, off, cur, cur, off, off, mode, Table, maxreq, reauth, global, default, default, default, svrtmout, raperiod, mode force

Table 112 802.1x Global Configuration Menu options

Command	Description
reauth onoff	Sets the re-authentication status to on or off. The default value is off.
default	Resets the global 802.1x parameters to their default values.
cur	Displays current global 802.1x parameters.

802.1x Port configurationCommand: /cfg/l2/8021x/port <port number>[802.1x Port Configuration Menu]

mode	- Set access control mode
qtperiod - Set EAP-Request/Identity quiet time interval
txperiod - Set EAP-Request/Identity retransmission timeout
suptmout - Set EAP-Request retransmission timeout
svrtmout	- Set server authentication request timeout
maxreq	- Set max number of EAP-Request retransmissions
raperiod	- Set reauthentication time interval
reauth	- Set reauthentication status to on or off
default	- Restore default 802.1x configuration
global	- Apply current global 802.1x configuration to this port
cur	- Display current 802.1x configuration

The 802.1x port menu allows you to configure parameters that affect the selected port in the switch. These settings override the global 802.1x parameters.

The following table describes the 802.1x Port Configuration Menu options.Table 113 802.1x Global Configuration Menu options

Command	Description
mode force-	Sets the type of access control for the port:
unauthautoforce-auth	• force-unauth—the port is unauthorized unconditionally.
	• auto—the port is unauthorized until it is successfully authorized by the
	RADIUS server.
	• force-auth—the port is authorized unconditionally, allowing all traffic.
	The default value is force-auth.
qtperiod <0-65535>	Sets the time, in seconds, the authenticator waits before transmitting an EAP-
	Request/ Identity frame to the supplicant (client) after an authentication failure
	in the previous round of authentication. The default value is 60 seconds.
txperiod <1-65535>	Sets the time, in seconds, the authenticator waits for an EAP-Response/Identity
	frame from the supplicant (client) before retransmitting an EAP-Request/Identity
	frame. The default value is 30 seconds.
suptmout <1-65535>	Sets the time, in seconds, the authenticator waits for an EAP-Response packet
	from the supplicant (client) before retransmitting the EAP-Request packet to the
	authentication server. The default value is 30 seconds.
svrtmout <1-65535>	Sets the time, in seconds, the authenticator waits for a response from the
	RADIUS server before declaring an authentication timeout. The default value is
	30 seconds.
	The time interval between transmissions of the RADIUS Access-Request packet
	containing the supplicant’s (client’s) EAP-Response packet is determined by the
	current setting of /cfg/sys/radius/timeout (default is 3 seconds).
maxreq <1-10>	Sets the maximum number of times the authenticator retransmits an EAP-Request
	packet to the supplicant (client). The default value is 2.
raperiod <1-604800>	Sets the time, in seconds, the authenticator waits before re-authenticating a
	supplicant (client) when periodic re-authentication is enabled. The default value
	is 3600 seconds.
reauth onoff	Sets the re-authentication status to on or off. The default value is off.
default	Resets the global 802.1x parameters to their default values.
	Configuration Menu 113