HP BL P-CLASS GBE2 331404-008 add, rem, cur, ena, dis, cur, mrto, aggr, srcip, clear, srcip, clear, robust, fastlv, timeout, qintrval, mrto <1-600, add <1-4095, rem <1-4095, robust <2-10

IGMP snooping configuration

Command: /cfg/l3/igmp/snoop[IGMP Snoop Menu]

timeout	- Set report timeout
mrto	- Set multicast router timeout
qintrval	- Set IGMP query interval
robust	- Set expected packet loss on subnet
aggr	- Aggregate IGMP report
srcip	- Set source ip to use when proxying GSQ
add	- Add VLAN(s) to IGMP Snooping
rem	- Remove VLAN(s) from IGMP Snooping
clear	- Remove all VLAN(s) from IGMP Snooping
fastlv	- Enable/disable Fastleave processing in VLAN
cur	- Display current IGMP Snooping configuration

The following table describes the IGMP Snoop Configuration Menu options.Table 156 IGMP Snoop Menu options

Command	Description
timeout <1-255>	Sets the Maximum Response Time (MRT) for IGMP hosts. MRT is one of
	the parameters used to determine the age out period of the IGMP hosts.
	Increasing the timeout increases the age out period.
	The range is from 1 to 255 seconds. The default is 10 seconds
mrto <1-600>	Configures the age-out period for the IGMP Mrouters in the Mrouter
	table. If the switch does not receive a General Query from the Mrouter
	for mrto seconds, the switch removes the multicast router from its
	Mrouter table.
	The range is from 1 to 600 seconds. The default is 255 seconds.
qintrval <1-600>	Sets the IGMP router query interval. The range is 1-600 seconds. The
	default value is 125.
robust <2-10>	Configures the IGMP Robustness variable, which allows you to tune the
	switch for expected packet loss on the subnet. If the subnet is expected to
	be lossy (high rate of packet loss), then increase the value. The default
	value is 2.
aggr disableenable	Enables or disables IGMP Membership Report aggregation.
srcip <IP address>	Configures the source IP address used as a proxy for IGMP Group
	Specific Queries.
add <1-4095>	Adds the VLAN to IGMP Snooping.
rem <1-4095>	Removes the VLAN from IGMP Snooping.
clear	Removes all VLANs from IGMP Snooping.
fastlv <1-4095> disableenable	Enables or disables Fastleave processing. Fastleave allows the switch to
	immediately remove a port from the IGMP port list, if the host sends a
	Leave message, and the proper conditions are met. This command is
	disabled by default.
ena	Enables IGMP Snooping.
dis	Disables IGMP Snooping.
cur	Displays the current IGMP Snooping parameters.

Configuration Menu 140