HP BL P-CLASS GBE2 331404-008 key, cur, add, rem, cur, all, cur, Table, Menu], enable, export, at end, Command, disable, Command, - Add rmap, Description, Description, metric <1-15

Table 145 RIP Interface Configuration Menu options

Command	Description
split disableenable	Enables or disables split horizon. The default value is enabled.
trigg disableenable	Enables or disables Triggered Updates. Triggered Updates are used to speed
	convergence. When enabled, Triggered Updates force a router to send update
	messages immediately, even if it is not yet time for the update message. The
	default value is disabled.
mcast disableenable	Enables or disables multicast updates of the routing table (using address
	224.0.0.9). The default value is enabled.
default disableenable	When enabled, the switch accepts RIP default routes from other routers, but
	gives them lower priority than configured default gateways. When disabled,
	the switch rejects RIP default routes. The default value is disabled.
metric <1-15>	Configures the route metric, which indicates the relative distance to the
	destination. The default value is 1.
auth nonepassword	Configures the authentication type. The default is none.
key	Configures the authentication key password.
enable	Enables this RIP interface.
disable	Disables this RIP interface.
cur	Displays the current RIP configuration.

RIP Route Redistribution configuration

Command: /cfg/l3/rip/redist fixedstaticospfeospf

[RIP Redistribute Fixed			Menu]
add	- Add rmap		into route redistribution list
rem	- Remove rmap from route redistribution list
export	-	Export all routes of this protocol
cur	-	Display current route-maps added

The following table describes the RIP Route Redistribute Menu options.Table 146 RIP Interface Configuration Menu options

Command	Description
add <1-32> <1-32>all	Adds selected routing maps to the RIP route redistribution list. To add all the 32
	route maps, enter all. To add specific route maps, enter routing map numbers
	one per line, NULL at the end.
	This option adds a route map to the route redistribution list. The routes of the
	redistribution protocol matched by the route maps in the route redistribution list
	will be redistributed.
remove <1-32> <1-32>all	Removes the route map from the RIP route redistribution list.
	Removes routing maps from the list. To remove all 32 route maps, enter all.
	To remove specific route maps, enter routing map numbers one per line, NULL
	at end.
export <1-15>none	Exports the routes of this protocol in which the metric and metric type are
	specified. To remove a previous configuration and stop exporting the routes of
	the protocol, enter none.
cur	Displays the current RIP route redistribute configuration.

Configuration Menu 133