HP BL P-CLASS GBE2 331404-008 ntp, cur, sshd, date, time, ssnmp, syslog, radius, access, olddst, tacacs+, enabled, timezone, disabled, idle <1-60, line> <'-'to end, bootp disable|enable

The following table describes the System Configuration Menu options.Table 80 System Configuration Menu options

Command	Usage
syslog	Displays the Syslog Menu.
sshd	Displays the SSH Server Menu.
radius	Displays the RADIUS Authentication Menu.
tacacs+	Displays the TACACS+ Menu.
ntp	Displays the Network Time Protocol (NTP) Server Menu.
ssnmp	Displays the System SNMP Menu.
access	Displays the System Access Menu.
date	Prompts the user for the system date.
time	Configures the system time using a 24-hour clock format.
timezone	Configures the time zone where the switch resides. You are prompted
	to select your location (continent, country, region) by the timezone
	wizard. Once a region is selected, the switch updates the time to
	reflect local changes to Daylight Savings Time, etc.
olddst	Enables or disables use of the Daylight Saving Time (DST) rules in
	effect prior to the year 2007. The default value is disabled.
idle <1-60>	Sets the idle timeout for CLI sessions, from 1 to 60 minutes. The default
	is 5 minutes.
notice <1-1024 character multi-	Displays login notice immediately before the “Enter password:”
line> <'-' to end>	prompt. This notice can contain up to 1024 characters and new lines.
bannr <1-80 characters>	Configures a login banner of up to 80 characters. When a user or
	administrator logs into the GbE2 Interconnect Switch, the login banner
	is displayed. It is also displayed as part of the output from the
	/info/sys/gen command.
hprompt disableenable	Enables or disables displaying of the host name (system administrator’s
	name) in the command line interface.
bootp disableenable	Enables or disables the use of BOOTP. If you enable BOOTP, the
	GbE2 Interconnect Switch will query its BOOTP server for all of the
	GbE2 Interconnect Switch IP parameters. The default is enable.
reminders disableenable	Enables or disables reminder messages in the CLI. The default value is
	enabled.
cur	Displays the current system parameters.

Configuration Menu 90