Link to Disable configuration

Command: /cfg/ufd/fdp/ltd

[Failure Link

to Disable Menu]

addport

- Add port to Link to Disable

remport

- Remove port from Link to Disable

addtrnk

- Add trunk to Link to Disable

remtrnk

- Remove trunk from Link to Disable

cur

- Display current LtD configuration

The following table describes the Link to Disable (LtD) Menu options. The LtD can consist of any mix of downlink ports (ports 1-16) and trunk groups that contain only downlink ports.

Table 189 Link to Disable Menu options

Command

Description

 

 

addport <port number>

Adds a port to the current LtD group. Only downlink ports (1-16) are allowed in the LtD.

 

 

remport <port number>

Removes a port from the current LtD group.

 

 

addtrunk <1-12>

Adds a trunk group to the current LtD group. LtD trunk groups can contain only downlink

 

ports (1-16).

 

 

remtrunk <1-12>Removes a trunk group from the current LtD group.

 

 

cur

Displays the current LtD configuration.

 

 

DumpCommand: /cfg/dump

The dump program writes the current GbE2 Interconnect Switch configuration to the terminal screen. To start the dump program, at the Configuration# prompt, enter:

Configuration# dump

The configuration is displayed with parameters that have been changed from the default values. The screen display can be captured, edited, and placed in a script file, which can be used to configure other GbE2 Interconnect Switches. Paste the configuration commands from the script file at the command line prompt of the GbE2 Interconnect Switch. The active configuration can also be saved or loaded via TFTP.

Saving the active GbE2 Interconnect Switch configurationCommand: /cfg/ptcfg <TFTP server> <filename>

When the ptcfg command is used, the active configuration commands of the GbE2 Interconnect Switch (as displayed using /cfg/dump) will be uploaded to the specified script configuration file on the TFTP server. To start the GbE2 Interconnect Switch configuration upload, at the Configuration# prompt, enter:

Configuration# ptcfg <TFTP server> <filename>

Where <TFTP server> is the TFTP server IP address or hostname and <filename> is the name of the target script configuration file.

NOTE: The output file is formatted with line-breaks but no carriage returns. The file cannot be viewed with editors that require carriage returns (such as Microsoft Notepad).

NOTE: If the TFTP server is running SunOS™ or the Solaris™ operating system, the specified ptcfg file must exist prior to executing the ptcfg command and must be writable (set with proper permission, and not locked by any application). The contents of the specified file will be replaced with the current configuration data.

Configuration Menu 159