HP C4381-90100 manual If You Have Problems, Installing the Software for Windows 95 or Windows NT

1-8 If You Have Problems

If You Have Problems

After connecting your CD-Writer Plus drive and turning on your computer, the computer should start (boot) as it normally does. If it does not, check the following items:

■Is the computer power plugged in?

■Is each device plugged in and turned on?

■Are all cables properly plugged into the back of your computer and the CD-Writer Plus drive?

■Try turning off your computer. Wait at least 20 seconds before turning it back on.

Installing the Software for Windows 95 or

Windows NT 4.0

After the CD-Writer Plus drive is attached to your computer, you are ready to install the application software.

NOTE: You must run the installation program. The installation program converts the files from the CD into a usable format.

If your computer DOES NOT have a CD-ROM drive:

1.To get your CD-Writer Plus started right away, insert the diskette labeled Driver Installation into your floppy drive.

2.Click the Start button on the task bar, select Run.

3.Type A:\SETUP (where A: is your floppy drive’s letter), and press ENTER. The parallel port driver files are installed. This may take several minutes and your mouse cursor will not move.

4.Windows NT only: Reboot your computer before continuing.

5.Insert the CD labeled “Software Disc 1” into your new CD-Writer Plus drive and proceed with step 2 in the next procedure.

NOTE: For information about inserting a CD into the CD-Writer Plus drive, see “Inserting a CD” on page 2-1.