connector) is wider and thicker and always has 8 contacts on the end. A phone connector has between 2 and 6 contacts.

❑A desktop computer or laptop with an Ethernet connection.

NOTE: The HP All-in-One supports both 10 Mbps and 100 Mbps Ethernet networks. If you are purchasing, or have purchased, a network interface card (NIC), make sure it can operate at either speed.

Connect the HP All-in-One to the network

To connect the HP All-in-One to the network, use the Ethernet port on the back of the device.

To connect the HP All-in-One to the network

1.Remove the yellow plug from the back of the HP All-in-One.

2.Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.

3.Connect the other end of the Ethernet cable to an available port on your Ethernet router or switch.

Finish setup

Connect to a network

31