Chapter 4

setup Finish

(continued)

Parameter

 

Description

 

 

 

 

Configuration

 

The protocol used to assign the IP address to the HP All-in-One:

Source

 

AutoIP: The installation software automatically determines the

 

 

 

 

configuration parameters.

 

 

DHCP: The configuration parameters are supplied by a dynamic host

 

 

configuration protocol (DHCP) server on the network. On small networks,

 

 

this could be a router.

 

 

Manual: The configuration parameters are set manually, such as a static

 

 

IP address.

 

 

Not Specified: The mode used when the HP All-in-One is initializing.

 

 

 

 

DNS server

 

The IP address of the domain name service (DNS) for the network. When you

 

 

use the web or send an e-mail message, you use a domain name to do it. For

 

 

example, the URL http://www.hp.com contains the domain name hp.com. The

 

 

DNS on the Internet translates the domain name into an IP address. Devices

 

 

use the IP addresses to refer to one another.

 

 

IP Address: The IP address of the domain name server.

 

 

Not Specified: The IP address is not specified, or the device is initializing.

 

 

 

 

 

 

NOTE: Check to see if a DNS IP address appears on the network

 

 

configuration page. If no address is shown, obtain the DNS IP address from

 

 

your Internet service provider (ISP).

 

 

 

 

 

 

 

 

Link

 

The speed at which data is transmitted over a network. Speeds include 10TX-

Configuration

 

Full, 10TX-Half,100TX-Full, and 100TX-Half. When set to None, networking

 

 

is disabled.

Total Packets

 

The number of packets transmitted by the HP All-in-One without error since

transmitted

 

it has been turned on. The counter clears after the HP All-in-One is turned

 

 

off. When a message is transmitted over a packet-switching network, it is

 

 

broken up into packets. Each packet contains the destination address as well

 

 

as the data.

 

 

 

Total Packets

 

The number of packets received by the HP All-in-One without error since it

received

 

has been turned on. The counter clears after the HP All-in-One is turned off.

 

 

 

 

48 Finish setting up the HP All-in-One