Chapter 4

setup Finish

Related topics

“View and print network settings” on page 41

Network configuration page definitions

The network configuration page shows the network settings for the HP All-in-One. There are settings for general information, 802.3 wired (Ethernet), 802.11 wireless, and Bluetooth®.

This section contains the following topics:

•General network settings

•Wired (802.3) network settings

•Wireless (802.11) network settings

•Bluetooth settings

Related topics

•“View and print network settings” on page 41

•“Network glossary” on page 52

General network settings

The following table describes the general network settings shown on the network configuration page.

Parameter

 

Description

 

 

 

 

Network Status

 

Status of the HP All-in-One:

 

 

• Ready: The HP All-in-One is ready to receive or transmit data.

 

 

• Offline: The HP All-in-One is not currently connected to the network.

 

 

 

 

Active connection

 

Network mode of the HP All-in-One:

type

 

• Wired: The HP All-in-One is connected by Ethernet cable to an IEEE

 

 

 

 

802.3 network.

 

 

• Wireless: The HP All-in-One is connected to a wireless (802.11) network.

 

 

• None: There is no network connection.

 

 

 

 

URL

 

The IP address of the Embedded Web Server.

 

 

 

 

 

 

NOTE: You will need to know this URL when you try to access the

 

 

Embedded Web Server.

 

 

 

 

 

 

 

 

Firmware

 

The internal networking component and device firmware revision code.

Revision

 

 

 

 

NOTE: If you call HP Support, depending on the problem, you might be

 

 

 

 

asked to provide the firmware revision code.

 

 

 

 

 

 

 

Hostname

 

The TCP/IP name assigned by the installation software to the device. By

 

 

default, this is the letters HP followed by the last 6 digits of the Media Access

 

 

Control (MAC) address.

46 Finish setting up the HP All-in-One