HP I Dual Channel Ultra160 SCSI Host Adapter A6829A manual Specifying Scsi Parameters

Installing the A6829A Adapter

Specifying SCSI Parameters

Table 2-2	Ability to Set SCSI Parameters on HP-UX Systems (Continued)
			Method for Setting Parameter
	HP-UX	SCSI	Firmware		Jumper
	System	Parameter		BCH	(for the
			Suggested
				Commands	Single
			Default
					Channel)
	hp server	SCSI ID	✓	✓
	rp8400
		Maximum	✓	✓
		data
		transfer rate
		Auto term			✓
		state1
		Bus width	✓	✓
	hp superd	SCSI ID	✓	✓
	ome
		Maximum
	servers
		data	✓	✓
		transfer rate
		Auto term			✓
		state1
		Bus width	✓	✓
	1See “Summary of Auto Termination Configurations” on page 39 for
	information on systems where you can use the jumper to control auto
	termination.

Information on configuring each of the SCSI parameters is given in the later sections.

26 Chapter 2