Troubleshooting

Setting and Confirming SCSI Parameters

Setting SCSI ID

To set the initiator SCSI ID for an adapter using the SCSI command, use the following syntax:

SCSI init bus_number slot_number ID_number

where

bus_number Specifies the number of the bus on which the adapter is installed.

slot_number Specifies the number of the slot the adapter is in.

ID_num

Specifies the adapter’s SCSI ID number.

For example, to set the SCSI ID for an adapter installed on bus 5 slot 2 to 6, issue the following command:

SCSI init 5 2 6

To display the result, issue the following command:

SCSI init 5 2

The output is as follows:

PCI device /5.2 = 6

Chapter 3

79

Page 93
Image 93
HP I Dual Channel Ultra160 SCSI Host Adapter A6829A manual Setting Scsi ID, Specifies the adapter’s Scsi ID number