Troubleshooting
NVRAM SCSI Parameters Do Not Match
| NVRAM SCSI Parameters Do Not Match |
| On hp servers rp7410, rp8400, and superdome only, you might see the |
| following message after you have installed the A6829A adapter (it would |
| be displayed at the BCH “Main Menu”): |
| ERROR: PDH NVRAM and I/O card NVRAM SCSI parameters |
| do not match for path hw_path |
| Search aborted. The SCSI parameters for this card |
| must be corrected from the BCH Service menu. |
| To correct this problem, follow these steps: |
Step | 1. If already at the “Main Menu,” type ser (for “Service Menu”); go to step |
| 2. |
| If not already at the “Main Menu,” type main (to return to the “Main |
| Menu”), type ser (for “Service Menu”), then go to step 2. |
Step | 2. In the “Service Menu,” type the following command: |
| scsi path default |
| where path is the HBA’s path (the hw_path in the error message). |
| This sets all of the SCSI parameters for the path to their default values, |
| which will correct the unmatching SCSI parameters. |
Step | 3. Type main to get back to the “Main Menu.” |
70 | Chapter 3 |
