Installing the A6829A Adapter
Specifying SCSI Parameters
| Setting SCSI Parameters to Default Values |
| You can set the SCSI parameters, except Auto Termination, for the |
| adapter to their default values through the BCH menus. The steps you |
| follow depend on the type of |
| installed. |
| hp servers rp7410, rp8400, and superdome |
| On hp servers rp7410, rp8400, and superdome, set the SCSI parameters |
| to the default values by performing the following steps: |
Step | 1. If you are already at the “Main Menu,” type ser (for “Service Menu”); go |
| to step 2. |
| If you are not at the “Main Menu,” type main (to return to the “Main |
| Menu”), type ser (for “Service Menu”), and then go to step 2. |
Step | 2. In the “Service Menu,” type the following command: |
| scsi path default |
| where, path is the HBA’s path. This sets all of the SCSI parameters for |
| the path to their default values. |
Step | 3. Type main to get back to the “Main Menu.” |
| All Other Servers |
| On all servers other than hp servers rp7410, rp8400, and superdome, set |
| the SCSI parameters to the default values by following the steps for |
| specifying each SCSI parameter (described earlier in this section). |
| You will need to know the default |
| SCSI parameter. To know the valid SCSI parameter values, HP |
| recommends you to use the online help for the scsi command (type |
| help scsi when you are in the BCH “Service Menu”). |
Chapter 2 | 53 |
