Installing the A6829A Adapter
Verifying Installation
•SCSI
•
Ultra160, Ultra2, Ultra, Fast, or Async. You should keep the following in mind:
—This is not the actual transfer rate, but the maximum transfer rate set for the HBA.
—This is either the firmware default or the rate set through the BCH menus, unless you attach an SE device, which causes the entire bus to change to a transfer rate of Ultra (see “Performance Tuning” on page 13).
•
•
•
|
| Step | 4. In addition, in the ioscan output, the ctl lines show the adapter’s SCSI | ||||
|
|
| ID in its hardware path (shown in bold in the example below, for | ||||
|
|
| highlighting purposes): |
|
| ||
ctl | 0 | 0/0/10/0/0.7.0 sctl CLAIMED | DEVICE | Initiator | |||
|
|
|
| /dev/rscsi/c0t7d0 |
|
| |
ctl | 1 | 0/0/10/0/1.7.0 sctl CLAIMED | DEVICE | Initiator | |||
|
|
|
| /dev/rscsi/c1t7d0 |
|
| |
|
| Step | 5. Verify that the devices you attached to the adapter are present in the | ||||
|
|
| ioscan output. For example, a partial list may look like this: | ||||
disk | 10 | 0/0/1/0/1.0.0 | sdisk | CLAIMED | DEVICE | SEAGATE ST39103LC | |
|
|
|
| /dev/dsk/c1t0d0 | /dev/rdsk/c1t0d0 | ||
disk | 11 | 0/0/1/0/1.2.0 | sdisk | CLAIMED | DEVICE | SEAGATE ST39103LC | |
|
|
|
| /dev/dsk/c1t2d0 | /dev/rdsk/c1t2d0 | ||
disk | 45 | 0/2/1/0/1.8.0 | sdisk | CLAIMED | DEVICE | HP 18.2GST318404LC | |
|
|
|
| /dev/dsk/c9t8d0 | /dev/rdsk/c9t8d0 | ||
disk | 46 | 0/2/1/0/1.10.0 sdisk | CLAIMED | DEVICE | HP 18.2GST318404LC | ||
|
|
|
| /dev/dsk/c9t10d0 | /dev/rdsk/c9t10d0 |
60 | Chapter 2 |