3.Slide the media guides in the tray to adjust them for the media size that you have loaded, and then lower the output tray.

4.Pull out the extension on the output tray.

To load small media

NOTE: If you are printing on thick paper (such as cardstock), you can use the rear manual feed slot. For more information, see Print with the rear manual feed slot.

1.Raise the output tray and remove any media from the input tray.

2.Insert a stack of media that does not exceed the height of the paper guide, print- side down along the right side of the input tray until it stops.

3.Open the small media guide by moving it 90 degrees clockwise from start to end position.

Load media

19