Configure IP network settings

4.When prompted, select the Wired Network - Connect the printer to your network using an Ethernet cable. option, and then click the Next button.

5.From the list of available printers, select the printer that has the correct IP address.

6.When the installation is complete, print a page from any program to make sure that the printing software is correctly installed.

View or change network settings

Use the embedded Web server to view or change IP configuration settings.

1.Print a configuration page, and locate the IP address.

●If you are using IPv4, the IP address contains only digits. It has this format: xxx.xxx.xxx.xxx

●If you are using IPv6, the IP address is a hexadecimal combination of characters and digits. It has a format similar to this:

xxxx::xxxx:xxxx:xxxx:xxxx

2.To open the HP Embedded Web Server, type the IP address (IPv4) into the address line of a Web browser. For IPv6, use the protocol established by the Web browser for entering IPv6 addresses.

3.Click the Networking tab to obtain network information. You can change settings as needed.

Set or change the product password

Use the HP Embedded Web Server to set a password or change an existing password for a product on a network so unauthorized users cannot change the product settings.

1.Type the product IP address into the address line of a Web browser. Click the Settings tab, click Security, and then click the Password Settings link.

NOTE: If a password has previously been set, you are prompted to type the password. Type “admin” for User Name along with the password, and then click the Apply button.