operation
hp learning products
http://www.hp.com/support/tape may have a later version
data protection
contact hp
home page
before you start
operation
the front panel lights loading & unloading
cartridge care
cleaning
specifications media compatibility diagnostics
troubleshooting 
FAQs
SCSI configuration 
UNIX configuration
ordering supplies
operation
| contents of this section |
|
|
| related topics |
| ||||
| switching on the drive |
|
|
| interpreting the front panel lights |
| ||||
| if you have problems during self |
|
|
| cartridges |
| ||||
| test |
|
|
| labeling and |
| ||||
| resetting the drive |
|
|
| loading and unloading |
|
|
| ||
|
|
|
|
| caring for |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
switching on the drive
Internal drives are powered on when you switch on your computer.
Switch on external drives using the power switch on the rear of the drive, and then switch on the computer.
if you have problems during self test
If all the LED lights on the front panel are flashing at the end of the
If you have just installed the drive, check the installation for loose connections and repeat the
Try the troubleshooting procedures to determine what the problem is.
If the fault condition persists, call for assistance.
resetting the drive
The drive can be reset without powering off the drive and computer, for example, if the drive stops responding. To reset the drive, press and hold the eject button until all three LEDs come on (which takes about 6 seconds), then release the button.
If the eject button is held down until the LEDS come on (6 seconds) and is continued to be held down, until the lights go off (another 4 seconds), no reset is performed.
If you press and hold the eject button again until the first two LEDs flash, the drive goes into a state ready for the firmware upgrade tape. The drive will returns to its normal state after
