Table
BIOS Error Codes, Messages, beeps
Action/FRU
NOTE: To diagnose a problem, first find the BIOS error messages, codes, or beeps in left column. If directed to a check procedure, replace the FRU indicated in the check procedure. If no check procedure is indicated, the first Action/FRU listed in right column is the most likely cause.
Memory test failure. | Insert the memory modules in the | |
| DIMM sockets properly, and then | |
| reboot the system. | |
| Memory module. See the “Step 005” | |
| of ”Memory” on page 95 to replace | |
| memory module. | |
| System board. | |
Keyboard error or no | Make sure the keyboard is connected | |
keyboard present. | properly and are set correctly in BIOS | |
| Setup. | |
| System board. | |
|
| |
FLOPPY DISK(S) | Floppy Type mismatch. | |
failure (40) |
| |
|
| |
Hard disk(s) | Make sure the hard disks are set | |
Diagnosis failure | correctly in BIOS setup. | |
| Hard disk drive cable/connection. | |
| Hard disk drive. | |
| System board. | |
|
| |
Primary master hard | A warning message to indicate there | |
disk failure | has been change of IDE Primary | |
| (Secondary) Channel Master (Slave) | |
Primary slave hard | device. | |
Load default settings in Setup. | ||
disk failure | ||
| ||
| Check IDE drive jumper. See | |
| Hard Disk Drive Jumper Locations” on | |
| page 133. | |
| IDE drive power. | |
| IDE drive cable/connection. | |
| IDE drive. |
76
