IBM 2169 manual CD-ROM Drive

Table 2-3 Error Symptoms List

Error Symptoms

Action/FRU

NOTE: To diagnose a problem, first find the error symptom in the left column. If directed to a check procedure, replace the FRU indicated in the check procedure. If no check procedure is indicated, the first Action/FRU listed in right column is the most likely cause.

Hard disk drive LED	With the system power on, measure
fails to light, but	the voltage of hard disk LED connector
system operates
normally.
	CD-ROM Drive

NOTE: Make sure CD-ROM drive is configured correctly in BIOS Setup, cable/jumper are set correctly and its laser beam is clean before diagnosing any CD-ROM drive problems.

CD-ROM drive LED	CD may have dirt or foreign material on
flashes for more	it. Check with a known good disc.
than 30 seconds	CD is not inserted properly.
before LED
	CD is damaged.
shutting off.
Software asks to
reinstall disc.
Software displays a
reading CD error.
CD-ROM drive LED	CD-ROM drive
doesn’t come on
but works normally.
CD-ROM drive cannot	CD-ROM drive power.
load or eject when	"CD-ROM Drive" on page 95.
the system is
	CD-ROM drive
turned on and its
eject button is
pressed and held.
CD-ROM drive does	CD may have dirt or foreign material on
not read and there	it. Check with a known good disc.
are no error codes	Make sure that the CD-ROM driver is
or messages are
	installed properly.
displayed.
	CD-ROM drive.

82