64 IBM Tivoli Remote Control Across Firewalls
6. This default port is for a Remote Control session and could be changed in the
rc_def_ports RC Policy. The default port for a File Transfer session is 2502
and could also be changed in the rc_def_ports RC Policy.
For more information about how to configure the RC Policies or the Proxy
configuration files, refer to the
IBM Tivoli Remote Control Users Guide
,
SC23-4842.
Table2-2 provides the same information as provided in Table 2-1 on page 63, but
in this situation, the Parent Proxy, which is the RC Target Proxy, is the
listener
.
The comments following the table refer to the numbered notes inside the table.
Table 2-2 RC ports for unidirectional communication - Parent/listener
Comments:
1. This port could be fixed in the rc_def_ports RC Policy.
2. This default port could be changed using the proxy-port parameter in the
[rcproxy] section of the Parent rcproxy.cfg file, in this case the RC Target
Proxy configuration file. This port must be the same as defined in the
rc_def_proxy RC Policy.
3. This port or port range could be fixed by configuring the local-port-range
parameter in the [parent-cm-info] section of the Child rcproxy.cfg file, in
this case the RC Controller Proxy configuration file.
Source Destination Protocol Description
Type
(Service)
Port
(Single /
Range)
Type
(Service)
Port
(Single /
Range)
Controller
(eqnrsmai)
random or
defined1
(single)
Target Proxy
(rcproxy)
94942
(single)
TCP Started at request.
Communication in the
same network zone.
No firewall rule needed.
Controller
Proxy
(rcproxy)
random or
defined3
(single or
range)
Target Proxy
(rcproxy)
defined4
(single)
TCP Started at service tim e.
Communication between
two network zones.
Firewall rule need ed.
Default polling interval is 2
seconds5.
Controller
Proxy
(rcproxy)
random
(single)
Target
(eqnrcmai)
25016
(single)
TCP Started at request.
Communication in the
same network zone.
No firewall rule needed.