
Chapter 2. Implementation planning 67
8. The default polling interval could be changed by configuring the
polling-interval parameter in the [children-cm-info] section of the Relay
Relay.cfg file, as it is the initiator.
9. This default port is for a Remote Control session and could be changed in the
rc_def_ports RC Policy. The default port for a File Transfer session is 2502
and could also be changed in the rc_def_ports RC Policy.
For more information about how to configure the RC Policies or the Proxy
configuration files, refer to the
IBM Tivoli Remote Control User’s Guide
,
SC23-4842.
Table2-4 provides the same information as given in Table 2-3 on page 65, but in
this situation, the Parent Proxies, which are the RC Target Proxy and the Relay
towards the RC Controller Proxy, are the
listeners. The comments following the
table refer to the numbered notes inside the table.
Table 2-4 RC ports for unidirectional communication - Relay - Parents/listeners
Source Destination Protocol Description
Type
(Service)
Port
(Single /
Range)
Type
(Service)
Port
(Single /
Range)
Controller
(eqnrsmai)
random or
defined1
(single)
Target Proxy
(rcproxy)
94942
(single)
TCP Started at request.
Communication in the
same network zone.
No firewall rule needed.
Relay
(Relay)
random or
defined3
(single or
range)
Target Proxy
(rcproxy)
defined4
(single)
TCP Started at service time.
Communication between
two network zones.
Firewall rule needed.
Default polling interval is 2
seconds5.
Controller
Proxy
(rcproxy)
random or
defined6
(single or
range)
Relay
(Relay)
defined7
(single)
TCP Started at service time.
Communication between
two network zones.
Firewall rule needed.
Default polling interval is 2
seconds8.
Controller
Proxy
(rcproxy)
random
(single or
range)
Target
(eqnrcmai)
25019
(single)
TCP Started at request.
Communication in the
same network zone.
No firewall rule needed.