IBM 4986B LanProbe manual 8 Modify/View Interface Values Menu

Local Terminal Configuration

Using a Local Terminal

Firmware Downloads TFTP firmware downloading.

3.Press S to save the configuration changes and return to LanProbe’s Main Menu. If you want to cancel your current changes and return to the LanProbe’s Main Menu, press 0.

Modify/View Interface Values

After you access the Modify/View Interface Values menu, you must first select the port that you want to configure and then configure that port. For example, the possible options for the port parameter could be the following:

z[1] 1.1/Ethernet

[2] 1.2/Serial

Use the following procedure to configure items in the Modify/View Interface Values menu:

1.Press 3 to access the Modify/View interface values menu item. The Modify/View Interface Values menu is displayed, as shown in Figure 2-8 on page 21.

Modify/View Interface Values Menu - Firmware Rev

MAC Address		00 00 C6 XX XX XX
Interface Type		Ethernet
1.	Port	1.1/Ethernet
2.	Port Type	Telemetry
3.	IP address	0.0.0.0
4.	Default gateway IP address	0.0.0.0
5.	Subnet mask	255.0.0.0
S. Save changes and exit
0.	Cancel changes and exit

Figure 2-8: Modify/View Interface Values Menu

21