IBM 4986B LanProbe manual Display Interface Summary

NOTE

Local Terminal Configuration

Using a Local Terminal

Display Interface Summary

Use the following procedure to view the Display Interface Summary screen for your LanProbe. Refer to Figure 2-9 on page 24.

1.Press 4, the Display Interface Summary item. The Display Interface Summary item displays the number and type of each interface, the port type, and each port’s IP address.

2.Press Enter to continue.

3.From LanProbe’s Main Menu, press 7 to execute a warm start or press 8 to execute a cold start. A cold start is required if you change the IP Address, Default Gateway or Subnet Mask. For either menu choice, LanProbe exits the Main Menu and restarts normal operations.

A warm start resets all data collected by the probe. A cold start resets all data collected by the probe and also resets any user-configuration information, such as history studies, filters, and alarms to their default values. Refer to Chapter 5 “LanProbe Operation” for more information on what is reset by warm and cold starts.

After the probe restarts (boots), it operates normally using the new configuration information. The warm start or cold start occurs immediately and there is no visual indication of when it finishes.

4.If you are performing the initial probe configuration, prepare LanProbe for installation by disconnecting the power cord. You will not lose your initial configuration information.

23