IBM 4986B LanProbe manual 10 Modify/View Serial Port Settings Menu

Local Terminal Configuration

Using a Local Terminal

Modify/View Interface Values Menu - Firmware Rev

Interface		Type	Serial
1.	Port		1.2/Serial
2.	Port Type		Not Applicable
3.	Serial	port IP address	0.0.0.0
4.	Serial	port subnet mask	255.255.252.192
5.	Serial	port speed	9600
6.	Serial	port mode	Direct
7.	Serial	port hardware flow control On
8.	Modem Init String		^s^M^d1^sATE0Q0V1X4 S0=1...
9.	Modem Hangup String		^d2^s+++^d2^sATH0^M^d2
10. Modem		Connect Responses	/CONNECT/300/CONNECT/1200/...
11. Modem		No-Connect Responses	/NO CARRIER/BUSY/NO DIALT...
S. Save Changes and Exit
0.	Cancel	Changes and Exit

Figure 2-10: Modify/View Serial Port Settings Menu

2.Select each field requiring configuration (one at a time) by selecting its corresponding number as shown in Figure 2-10 and then entering the values that are appropriate for your modem’s serial port.

Serial port IP address	Press 3 and then enter the serial port IP address for the
	probe. The default Serial Port IP Address is 0.0.0.0.
Serial port	Press 4 and then enter the serial port subnet mask for
subnet mask	the probe (optional). It is recommended that you do not
	change the serial port subnet mask unless there is a
	conflict. The default Serial Port Subnet Mask is
	255.255.255.192.

25