IBM 4986B LanProbe Cycling Power, Selecting the Warm Start Menu Item, 18 LanProbe’s Main Menu

LanProbe Operation

Restarting the Probe

Cycling Power

A power outage or cycling power to LanProbe causes a warm start. LanProbe does not have a power switch; therefore, cycling the power consists of disconnecting and reconnecting the power cord.

Selecting the Warm Start Menu Item

Use the following procedure to warm start the probe using LanProbe’s Main Menu:

1.Connect a local terminal (or a PC emulating a terminal) to LanProbe. Refer to Chapter 2 “Local Terminal Configuration” for information on connecting a local terminal.

2.Press the CONFIG button once (on the back of the probe) to place LanProbe into the configuration mode. Use a narrow, pointed object (like a pen) to press the recessed CONFIG button. LanProbe then displays its Main Menu on the terminal. Figure 5-18 shows LanProbe’s Main Menu.

Main Menu - Revision

1.Modify/View configuration values ->

2.Modify/View security values ->

3.Modify/View interface values ->

4.Display interface summary

5.TFTP Download new firmware ->

6.XMODEM Download new firmware ->

7.Warm start and Exit

8.Cold start and Exit

Figure 5-18: LanProbe’s Main Menu

73