IBM 4986B LanProbe manual Table Installation, Rack or Cabinet Installation

Installation

Installing the Probe

Table Installation

Place the probe on a flat surface or table (refer to the requirements listed in “Selecting a Location” on page 31).

Rack or Cabinet Installation

The LanProbe Rack Mount Kit is optional. The Agilent J2886A Rack Mount Kit provides a support shelf and hardware for mounting LanProbe in a rack or cabinet. The rack mounting kit requires a 3 1/2” slot in your rack and you will need a POZIDRIVâ #1 screwdriver. The LanProbe Rack Mount Kit includes the following:

One Support Shelf

One TORX‚T10 wrench

Four Clip-on sheet metal nuts

Four 0.55” (14 mm) 10-32 POZIDRIV â‚ screws

Four 0.75” (19 mm) #M4 self-tapping POZIDRIV â‚ screws

One LanProbe slot Cover

zTwo 0.312” (7.93 mm) #M3 machine screws Four Dual Lock Reclosable Fasteners‚ strips

Optional Accessories

zSupport Rail Kit (12679C)

Female-Male Power Cable, 30” (8120-1575)

Use the following procedure to install LanProbe in a rack or cabinet (refer to the requirements as listed in “Selecting a Location” on page 31 for additional information):

1.Place LanProbe on its top with the front facing you.

2.Remove the two screws that are in the lower right-hand corner and in the upper left-hand corner (looking down on LanProbe).

33