IBM 4986B LanProbe manual Starting the Probe

Installation

Starting the Probe

Starting the Probe

NOTE	If you are using the Bootp server method of configuration, do not attach the power
	cord and Agilent Power Module (0950-2546) to the probe until told to do so in
	Chapter 4 “Bootp Server Configuration”.
	If you used the local terminal method of configuration, attach the power cord and
	Agilent Power Module to LanProbe. The probe does not have a power switch, but
	is powered on when power is attached. When powered on or reset, LanProbe runs
	self-tests and transmits ICMP echo frames to the default gateway for the purpose
	of allowing the probe to be discovered by the routers (ARP cache). The probe
	transmits four ICMP echo request packets about 10 seconds after booting and
	again every autodiscovery echo interval. Refer to Chapter 5 “LanProbe
	Operation” for more information on resetting the probe.

47