Chapter 1
Installation
Components
The 802 Terminal is 802.11b compatible operating between 2399.5 MHz and 2474.5 MHz using direct sequence spread spectrum; it works with Access Points that are 802.11b or 802.11g compatible (b is a subset of g). The components in your 802 Terminal system will vary according to the configuration of your system. Your R/F Terminal shipment should contain at least:
•An R/F Terminal T802 or LT802 (unit includes keypad and display). If the R/F Terminal is an LT802 model, it will have an integrated laser scanner
•An optional Scanner – if you ordered the T802 models instead of the LT802 models with the
•Optional rechargeable batteries and a 9v power supply.
•802 Utilities CD ROM – demo programs, Active X development software, test program, and firmware loader program
Keep the shipping box for the R/F Terminal in the event it is necessary to return equipment for repair later.
Installation Tips
1.Be sure all Access Points and Terminals have the same SSID and WEP Key, (if Encryption is used). Terminals are shipped with a SSID of
WORTH DATA.
2.Start with one Terminal. Get everything working with the single terminal and then add other terminals, being certain that all terminals have unique IP Device Address.
3.Use the 802 Test Programs to validate that everything is working. If you have problems, refer to the Trouble Shooting Section.
Using the RF Terminal keypad…
The R/F Terminal is turned on by pressing the green ON/OFF button located in the upper
The R/F Terminal has a Shut Down Time feature that allows you to determine the length of time the R/F Terminal must be inactive before automatically shutting down to conserve battery power. When the R/F
