Terminal Error Messages
Message
Looking for App Server Please Wait
TERMINAL OUT OF RANGE, PRESS ANY KEY TO RETRY
Server Not Available Press Any Key
Looking for DHCP Server Please Wait
No DHCP Server Found
WAITING ON HOST PROMPT, Please Wait
Transmission Delayed, Press Any Key
Server Shut Down Due to Host Logic Error, Press Any Key
Server
LOW BATTERIES
Finish, Sign Off
Change Batteries
CHANGE BATTERIES UNIT SHUT DOWN
Cannot Communicate with PIC Processor
Radio not Responding
Meaning – Action Required
This is a normal message, generated when the Terminal Device first tries to establish contact with a Server.
The Terminal is not within range of any Access Point – regardless of SSID or encryption settings. Move closer or hold up to retry. If persistent, do a Site Survey.
Terminal is configured to search for Application Server, but it could not find it.
Terminal is configured to get its IP address from a DHCP Server. It is broadcasting search.
Terminal is configured to obtain IP Address from DHCP Server, but it could not find a DHCP Server
The Server has been found. The host program has not sent out a prompt yet. If this lasts more than 6 seconds, check the host application program for a logic bug.
This is an indication that the Radio was reset by the firmware – normally a rare condition. If you see it more than once per week, please call us with information on what you were doing at the time it occurred.
Problem is in host program. Notify programmer!
If the Server detects 5 Sequence Errors in a row, or 5 messages to a Terminal not Signed In, or 5 Illegal Commands, the Server transmits the message to all terminals signed in and shuts down. Check your host program and correct the logic error before starting up again.
The Server was rebooted. Press any key to be transferred to the Mode menu.
Finish the transaction you have started. The Press F1 to Sign Out. Then turn off the Terminal and change the batteries.
The terminal will display this message for 20 seconds, sign out, and turn off.
Change the batteries immediately. Don’t let someone else pick it up and operate with partially recovered batteries
The Terminal cannot communicate with the radio's PIC processor. Cycle power. If message persists, call for RMA.
The terminal's radio is not responding, Call for an RMA.
