Worth Data 802 RF user manual Recv Setup/Voice Please Wait, Xmit Setup/Voice Please Wait

You need 2 cables to clone 802 RF Terminals; the Data Cloning Cable #F38 and the Voice Cloning Cable #T15. The Data Cloning Cable plugs

into the “Computer” port on each 802 RF Terminal. This cable must be connected to clone properly.

One jack on the Voice Cloning Cable has two black rings on it – this end must plug in to the RECEIVING 802 RF Terminal (the one you are transmitting to). Plug the single-banded jack end into the MASTER 802 RF

Terminal (the one you are going to record from).

Once both cables are plugged in to both Terminals, go to the Setup Menu on both Terminals. Select 3 for Voice Operations from the menu.

The “Receiving” 802 RF Terminal must be started first. On the receiving Terminal, press the 4 key for Cloning Receiver. The “Receiving” unit will

display:

Recv Setup/Voice

Please Wait_

Now you can start the “Master” 802 RF Terminal by pressing the 3 key for Cloning Master. The “Master” Terminal will display:

Xmit Setup/Voice

Please Wait_

During the cloning process, you will hear the voice messages played aloud as they are copied. The process takes about 75 seconds to complete. After the Terminals are done cloning, they will both display:

End of Cloning

Hit Any Key_

If you did not hear the correct messages or you heard no messages at all, check your cables and receiver/master setup - you may have transmitted from the wrong 802 RF Terminal.

DATA XMIT ERROR

CYCLE POWER

If you get the DATA XMIT ERROR message, you have to restart the whole cloning procedure.

7-5