System reliability guidelines

To help ensure proper system cooling and system reliability, make sure that the following requirements are met:

vEach of the drive bays has a drive or a filler panel and electromagnetic compatibility (EMC) shield installed in it.

vThere is adequate space around the server to allow the server cooling system to work properly. Leave approximately 50 mm (2 in.) of open space around the front and rear of the server. Do not place objects in front of the fans. For proper cooling and airflow, replace the server cover before turning on the server. Operating the server for extended periods of time (more than 30 minutes) with the server cover removed might damage server components.

When installing the server in a rack, make sure that space is available around the server to enable the server cooling system to work properly. See the documentation that comes with the rack for additional information.

vYou have followed the cabling instructions that come with optional adapters.

vYou have replaced a failed fan within 48 hours.

vYou have replaced a hot-swap drive within 2 minutes of removal.

Working inside the server with the power on

Attention: Static electricity that is released to internal server components when the server is powered-on might cause the server to halt, which could result in the loss of data. To avoid this potential problem, always use an electrostatic-discharge wrist strap or other grounding system when working inside the server with the power on.

The server supports hot-plug, hot-add, and hot-swap devices and is designed to operate safely while it is turned on and the cover is removed. Follow these guidelines when you work inside a server that is turned on.

vAvoid wearing loose-fitting clothing on your forearms. Button long-sleeved shirts before working inside the server; do not wear cuff links while you are working inside the server.

vDo not allow your necktie or scarf to hang inside the server.

vRemove jewelry, such as bracelets, necklaces, rings, and loose-fitting wrist watches.

vRemove items from your shirt pocket, such as pens and pencils, that could fall into the server as you lean over it.

vAvoid dropping any metallic objects, such as paper clips, hairpins, and screws, into the server.

8xSeries 206m Types 8485 and 8490: Installation Guide

Page 22
Image 22
IBM 8485, 8490 manual System reliability guidelines, Working inside the server with the power on