Initio INI-9100UW user manual Installing the Initio driver in a new UnixWare system, 11-3

∙Host adapter interrupt level must be set to IRQ 10 for proper installation of the Initio driver.

Please refer to your system documentation to set the interrupt levels and your peripheral documentation for help in setting SCSI IDs.

Installing the Initio driver in a new UnixWare system

Drivers for the Initio host adapter may be found on the INITIO INI- 9100U/9100UW DRIVER DISK 2. In most cases you will load the drivers during a new installation of UnixWare from CD-ROM. The driver is loaded during the early stages of the installation procedure. The UnixWare installation program will prompt you for the required parameters as the installation procedure progresses. It is highly recommended that you have a copy of the SCO UnixWare Installation Handbook and SCO UnixWare System Owner Handbook for reference.

1.Insert the “SCO UNIXWARE INSTALLATION DISKETTE” into the floppy drive and turn on the computer. A screen similar to the following will be displayed (see figure 11-1).

figure 11-1UnixWare Installation

11-3