System BIOS CBI/CGI Technical Reference
Chassis Plans3-10
OnBoard Parallel Port
Parallel Port Mode
EPP Version
Parallel Port IRQ
Parallel Port DMA Channel
OnBoard IDE
Select Auto-Detect Hard Disks to have AMIBIOS automatically detect the
type and parameters of each hard drive if you have IDE drive(s). This
option is described later in this chapter.
Select Change User Password to establish or change the password for the
user. This function is described later in this chapter.
Select Change Supervisor Password to establish or change the password
for the supervisor. This function is described later in this chapter.
Select Auto Configuration with Optimal Settings to load the Optimal
default settings. These settings are best-case values which should provide
the best performance characteristics. This function is described later in this
chapter.
Select Auto Configuration with Fail Safe Settings to load the Fail Safe
default settings. These settings are more likely to configure a workable
computer, but they may not provide optimal performance. This function is
described later in this chapter.
Select Save Settings and Exit to store your changes in the CMOS. The
CMOS checksum is calculated and written to the CMOS. Control is then
passed back to AMIBIOS and the booting process continues, using the new
CMOS values. This function is described later in this chapter.
Select Exit Without Saving to pass control back to the AMIBIOS without
writing any changes to the CMOS. AMIBIOS continues with the booting
process. This function is described later in this chapter.