Power Management SetupCBI/CGI Technical Reference

Chassis Plans. 6-1

Chapter 6 Power Management Setup
POWER
MANAGEMENT
SETUP
When you select Power Management Setup from the AMIBIOS Setup Utility Main
Menu, the following Setup screen displays:
Power Management Setup Screen
When you display the Power Management Setup screen, the format is similar to the
sample shown above, except the screen displays only twenty options at a time. If you
need to change other options, use the down arrow key to locate the appropriate option.
The available values for each option are displayed on the right side of the screen when
you tab or arrow into the field.
_______________________________________________________________________
NOTE: The values on this screen do not necessarily reflect the values appropriate for
your SBC. Refer to the explanations below for specific instructions about entering
correct information.
_______________________________________________________________________
POWER
MANAGEMENT
SETUP OPTIONS
The descriptions for the system options listed below show the values as they appear if
you have not yet run Power Management Setup. Once values have been defined, they
display each time Power Management Setup is run.
ACPI Aware O/S
This option indicates whether or not the operating system under which you are running
complies with Intel's Advanced Configuration and Power Interface (ACPI) specification.
AMIBIOS SETUP - POWER MANAGEMENT SETUP
(C)1998 American Megatrends, Inc. All Rights Reserved
ACPI Aware O/S No
Power Management/APM Disabled
Power Button Function On/Off
Green PC Monitor Power State Stand By
Video Power Down Mode Disabled
Hard Disk Power Down Mode Disabled
Hard Disk Time Out (Minute) Disabled
Power Saving Type POS
Standby/Suspend Timer Unit 4 Min
Standby Time Out Disabled
Suspend Time Out Disabled
Slow Clock Ratio 50%-62.5%
Display Activity Ignore
Device 6 (Serial port 1) Ignore
Device 7 (Serial port 1) Ignore
Device 8 (Parallel port) Ignore
Device 5 (Floppy disk) Ignore
Device 0 (Primary master IDE) Ignore
Device 1 (Primary slave IDE) Ignore
Device 2 (Secondary master IDE) Ignore
Device 3 (Secondary slave IDE) Ignore
Available Options:
No
Yes
ESC:Exit ↑↓:Sel
PgUp/PgDn:Modify
F2/F3:Color