Intel STL2 manual Revision, 3-25

STL2 Server Board TPS		Server Management
Sensor Number	Sensor Type	Monitoring Device
94h	BIOS POST (Error) Code
95h	Log Disable	Log Area Reset / Cleared (bit 2)
		ECC single bit Error Disable (bit 0)
96h	System Event	OEM System Event (Hard Reset) (bit 1) System
97h	Critical Interrupt	PCI SERR (bit 5)
		PCI PERR (bit 4)
		Front Panel NMI (Dump SW) (bit 0)
98h	Button	Reset Button (bit 2)
		Sleep Button (bit 1)
		Power Button (bit 0)
99h	No Processor or Termination Board
9Ah	Boot Init	User requested PXE boot (bit 3)
		Initiated by power up (bit 0)
9Bh	Boot Error	PXE Server not found (bit 2)
		No bootable media (bit 0)
9Ch	OS Boot
9Dh	OS Stop
9Eh	ACPI State	Sleeping in S1 state (bit 8)
		G3/Mechanical Off (bit 7)
		S5 / G2 Soft Off (bit 5)
		S4 (bit 4)
A0h	BMC Watchdog	BMC WDT Timeout
C0h	Chassis Intrusion ID (Disable)	Processor Area Intrusion (bit 4)
C1h	Chassis Intrusion ID	Drive Bay Intrusion (bit 1)
F3h	SMI State	SMI Stall State

The following table provides a list of System Event Log (SEL) events supported by the STL2 server board.

Sensor Type	Sensor Type	Sensor-Specific	Event	Remarks
	Code	Offset
Reserved	00h	–	Reserved
Temperature	01h	–	Temperature	An error occurred at thermal sensors
Voltage	02h	–	Voltage	An error occurred at voltage sensors
		01h	Performance Lags	In the single-end event mode, even if
				SCSI is available for a different
				mode event.
Fan	04h	–	Fan	An error occurred at fan sensors.
Physical Security	05h	01h	Drive Bay Intrusion	Front cover has been opened or
				closed
		03h	Processor area intrusion	Side (Chassis) cover has been
				opened or closed.
		04h	LAN Connection Lost
(System has been	LAN cable has
unplugged from LAN)	been plugged
	in or
	unplugged.

Revision 1.0 3-25